Fitting Advice (very easy)

Typically number plates are simply either stuck on with cushioned sticky pads or screwed on. Typically you should opt for the same fitting method as currently used when replacing your plates, although this is not always necessary.

​

For 4D/3D letter plates the ideal way to mount your plate is simply by using 3M stickers that we can provide at a small cost. This is not always possible dependant on your car i.e. if car surface is curved where plate is mounted.

​

Using 3M cushioned Sticky pads

If using 3M sticky pads for fitting then we suggest you give the area behind you old plate a really good clean and degrease and dry before sticking on the new plate.

​

Drilling holes in New Plate for Screws

If you do need to drill your new plate for screw mounts we cannot be responsible for any damage caused to the product during drilling. But if you do drill the plate we advise you :-

1) Use you old plate as template to get the holes in the same position.

2) Then place some masking tape on the rear of the plate where you need to drill.

3) Then drill from the back of the plate,  also start with a small pilot hole and then widen hole as required. Do not apply any pressure to the drill and allow the drill bit to do the work.

​

If you need any further advice we are always here to help.